Rossi’s ECAT LENR/Cold Fusion Independently Tested and Confirmed

From Forbes.com

Finally! Independent Testing Of Rossi’s E-Cat Cold Fusion Device: Maybe The World Will Change After All

While a few commentators have raised criticisms concerning how the measurements were made and sources of error others have argued that the energy produced is so significant even knocking off an order of magnitude on either axis still portrays a process with insanely valuable output.

http://www.forbes.com/sites/markgibbs/2013/05/20/finally-independent-testing-of-rossis-e-cat-cold-fusion-device-maybe-the-world-will-change-after-all/

“Published on May 16, the paper titled “Indication of anomalous heat energy production in a reactor device” would appear to deliver what we wanted.

The paper was authored by Giuseppe Levi of Bologna University, Bologna, Italy; Evelyn Foschi, Bologna, Italy; Torbjörn HartmanBo HöistadRoland Pettersson and Lars Tegnér of Uppsala University, Uppsala, Sweden; andHanno Essén, of the Royal Institute of Technology, Stockholm, Sweden. While some of these people have previously been public in their support of Rossi and the E-Cat they are all serious academics with reputations to lose and the paper is detailed and thorough.

The actual test reactor, called the E-Cat HT, was described by the testers as:

… a high temperature development of the original apparatus which has also undergone many construction changes in the last two years – is the latest product manufactured by Leonardo Corporation: it is a device allegedly capable of producing heat from some type of reaction the origin of which is unknown.

They described the E-Cat HT as:

… a cylinder having a silicon nitride ceramic outer shell, 33 cm in length, and 10 cm in diameter. A second cylinder made of a different ceramic material (corundum) was located within the shell, and housed three delta-connected spiral-wire resistor coils. Resistors were laid out horizontally, parallel to and equidistant from the cylinder axis, and were as long as the cylinder itself. They were fed by a TRIAC power regulator device which interrupted each phase periodically, in order to modulate power input with an industrial trade secret waveform. This procedure, needed to properly activate the E-Cat HT charge, had no bearing whatsoever on the power consumption of the device, which remained constant throughout the test. The most important element of the E-Cat HT was lodged inside the structure. It consisted of an AISI 310 steel cylinder, 3 mm thick and 33 mm in diameter, housing the powder charges. Two AISI 316 steel cone-shaped caps were hot-hammered in the cylinder, sealing it hermetically.”

Submit a Comment

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>